TDK-Lambda’s Z+ high-density, 2 U format, bench-top and rack-mountable power supplies are designed to meet the demands of a wide variety of ATE, laboratory and OEM applications, including test and measurement, semiconductor burn-in, component test, LED/Laser test, RF amplifiers, electromagnetic and electrochemical.
The Z+ models can provide between 200 to 800 W of output power with output voltages from 0 to 650 VDC and output currents up to 72 A. The Z+ devices are 33% smaller and 40% lighter than the previous generation (ZUP series) and similar products, thus providing a 49% increase in power density. The standard models are only 3.27" high by 2.76" wide, so up to 6 units can be installed in the optional 19" rack housing and blanking plates are available for unused slots. Options for front panel output-jacks and multiple-unit housings are available for bench-top applications.
| Features and Benefits |
|
|
- 2 U high
- Built-in USB, RS-232 and RS-485 interface
- Optional LAN, GPIB and Isolated Analog programming
|
|
- Bench or rack mount
- Constant-current or voltage modes
- Five-year warranty
|
| Applications |
|
|
- Test and Measurement
- Built-in Last-Setting memory based on flash memory; no battery or capacitor backup simplifies test design and requirements.
- Built-in RS-232/RS-485 gives maximum system flexibility along with 0-5 V and 0-10 V selectable analog programming.
- Wide range of available inputs allows testing of many different devices.
- Semiconductor Burn-in
- Safe-Start mode ENABLED to re-start at Output OFF to protect load.
- Wide range input (85-265 VAC) with Active Power Factor correction rides through input transients easily.
- Component Test
- High power density, zero-stacking, and single-wire parallel operation give maximum system flexibility.
|
|
- Laser Diode
- OVP is directly set on Voltage Display, assuring accurate protection settings.
- Fast constant current response with no over-shoot.
- Current Limit FoldBack assures load is protected from current surges.
- Heater Supplies
- Smooth, reliable encoders enhance front panel control.
- Remote analog programming is user selectable at 0-5 V or 0-10 V.
- RF Amplifiers and Magnets
- Robust design assures stable operation under a wide variety of loads, with high linearity in voltage and current modes.
|
